Sequential Dosing System
The mix ratio is higher than the set tolerance on the previous dose cycle.
Dynamic Dosing System
The mix ratio is higher than the set tolerance for an A to B component volume comparison.
Restrict gun needle travel to slow down the initial fluid delivery rate until fluid hoses are loaded with material.
Adjust component A and B fluid supply regulator pressures until they are about equal. If the pressures are already about equal, verify that component A and B dose valves are operating properly.
Manually operate the Dispense A and B solenoid valves as instructed in the ProMix 2KS Repair-Parts manual to check operation.
Increase air pressure. Air pressure must be 75-120 psi (0.52-0.84 MPa, 5.2-8.4 bar); 120 psi is recommended.
There may be dirt or moisture in the air supply. Filter appropriately.
Refer to: Mix Manifold Valve Settings, in manual, for adjustment guidelines.
Adjust air and fluid pressure. See recommended air pressure above.