SC01 : Pressure Imbalance

To avoid serious injury follow all warnings and instructions in the manual. Wear appropriate personal protective equipment.

NOTE: The unit does not check for pressure imbalance at setpoints less than 300 psi (2.1 MPa, 21 bar).

NOTE: The unit does not check for pressure imbalance for 10 sec after entering pressure mode.

To turn off automatic shutdown and/or tighten pressure tolerances for status code 1, see DIP Switch Settings, in manual.

Reduce pressure of higher component by slightly turning Recirc/Spray valve for that component toward Recirc, until gauges show balanced pressures.
If pressure imbalance continues, see Proportioner Troubleshooting, in manual.