Products
Protective Coatings
Xtreme Sprayers
Manuals
Training
Maintenance Schedule
1-866-361-5959
North America Support
Global Support
ENTER ERROR CODE
Code was not found!
Troubleshooting Advice for Xtreme Sprayers
Air blowing out rear main motor exhaust.
Air bubbles in fluid.
Air continuously exhausting around motor shaft.
Air continuously exhausting from muffler on up and down strokes.
Air motor “bounces” at top or bottom of the stroke.
Air pressure jumps to line input pressure from set point.
Air pressure varies 5 - 10 psi from set point.
Built in air inlet gauge reads zero "0".
Cycles or fails to hold pressure at stall.
Does not operate.
Erratic accelerated speed.
Motor runs at 20 - 50 psi, but stops if input air pressure is 50 psi or greater.
Motor runs below 10 psi air input pressure.
Motor runs only at 50 psi or greater.
Motor runs slow.
Motor stuck at top or bottom stroke of piston.
Output low on both strokes.
Output low on down stroke.
Output low on upstroke.
Poor finish or irregular spray pattern.
Poppet valve or valves leaking constantly though poppet muffler exhaust.
Runaway error code displayed, pump running faster than set runaway limit.
Runaway error code does not clear.
Runs sluggishly.
Slow motor reversal.