Graco Logo
  1. Products
  2. Protective Coatings

Xtreme XL

To avoid serious injury follow all warnings and instructions in the manual. Wear appropriate personal protective equipment.

Manuals
Maintenance Schedule
Operation Videos
1-866-361-5959
North America Support
Global Support

Code was not found!

Troubleshooting Advice for Xtreme XL

  • Air bubbles in fluid.
  • Air exhausts from rear outlet continuously when motor is stalled against fluid valve on one stroke or the other.
  • Air motor "bounces" at bottom change over.
  • Air motor "bounces" at top change over.
  • Air motor doesn't run and large volume of air blows through exhaust outlet on either stroke.
  • Air motor pauses at bottom change over.
  • Air motor pauses at top change over.
  • Air motor will not run and there is no obvious exhaust.
  • Cycles or fails to hold pressure at stall.
  • Does not operate.
  • Erratic accelerated speed.
  • Motor runs slower and pump looses fluid pressure on both strokes equally.
  • Motor runs slower and pump looses fluid pressure on one stroke only.
  • Motor stalled at bottom of stroke with exhaust at bottom pilot. Some exhaust at top pilot.
  • Motor stalled at bottom of stroke with no exhaust at bottom pilot. No exhaust at top pilot.
  • Motor stalled at top of stroke with exhaust at top pilot. Some exhaust at bottom pilot.
  • Motor stalled at top of stroke with no exhaust at top pilot. No exhaust at bottom pilot.
  • Output low on both strokes.
  • Output low on down stroke.
  • Poor finish or irregular spray pattern.
  • Runs sluggishly.
  • Xtreme XL Operation Videos
© Graco Inc. All rights reserved.
  • Privacy Policy
  • Terms of Service
  • Trademarks
  • Cookie Settings
    Privacy Preferences
Graco Logo