Products
Reactor and Gusmer Products
Gusmer: H-20/35
Hose Does Not Heat
Connected hose uses RTD (resistance temperature detector) instead of a thermocouple.
The Gusmer proportioner requires standard, 2-component heated hoses with thermocouple.
FTS failed
Check FTS. See Repair Fluid Temperature Sensor (FTS), in manual.
FTS not installed correctly
FTS should be installed close to end of hose in same environment as gun. Verify FTS installation. See Repair Fluid Temperature Sensor (FTS), in manual.
Loose hose electrical connections
Check connections. Repair as necessary.
Circuit breakers tripped
Reset breakers CB3 and CB5. See Electrical Enclosure, in manual.
Hose zone not turned on
Turn on hose heat zone.
A and B temperature setpoints too low
Check setpoints. Increase if necessary.